Home | About Us | Certificates | Catalog | Solution | Contact Us | Quality Control  
Stamped parts
Die casted parts
Lathe machined parts
Deep drawn parts
Milled Parts
Die Spun Parts
Electroplated parts
Power coated parts
Plastic injected parts
Sheet metal stamping
Metal welding
Moulds building
Metal extruding
Aluminum die casting
Metal Machining
Metal finishing
Metal bending
Plastic injection molding

Stainless Steel

Stainless steel be fed through the machine with coil or sheet strip. Because of the stiffness of the stainless steel, the dies material needs a good tensil strength and hardened very well. Cr12MoV be considered as right material.The vaccum heat treating will be consider to harden the die material. The tooling cost will be highter.

Comparing to copper, carbon steel, aluminum or other material, stainless steel is the most difficult work involved in our stamping process.

Stainless steel usually use for brackets which apply in the chemical pools can bear many harmful chemical factors and virus.  A lot of cookware also made from stainless steel as 304 and 316.

Stainless Steel Wall Hook

CopyRight©2020 湖南龙励电气有限公司 湘ICP备19002922号-1 91430121399123079L